#Cinch knot how to#
#Cinch knot pro#
#Cinch knot free#

Lift and stretch each of your horse’s front legs out in front as far as he or she will allow. There is one more step to protect your horse’s comfort and avoid saddle sores once you have done tightening your cinch. The goal of this method is not to get the cinch as tight as possible, but to develop a pleasant process that turns the horse into a willing participant. Continue to move the horse around and then slowly tighten. Allow the horse to settle by moving it around (circle, back up, sideways). To begin, carefully tighten it until it is snug. Tightening in three phases is a wonderful habit to develop. Instead of tightening a cinch all at once, it should be done in phases. A horse may find a long latigo left dangling irritating or terrifying.

If the latigo is short enough, it can either hang loose or be fed through the latigo holder.

Make sure the tongue lodges against the ring by pulling down on the top latigo layer.

#Cinch knot free#

Instead of knotting the free end, loop it back through the cinch ring and hook one of the latigo holes on the buckle tongue.

Follow steps 1 through 4 above with a cinch buckle.Take up the slack in the knot loop with your other hand and pass it through the saddle dee.

You will keep the innermost loop if you have taken numerous wraps.

Hold the top loop of the latigo that has gone through the cinch ring (NOT the loose end) with one hand and slowly pull up to tighten the cinch.

It is comparable to how a man ties his tie. Thread the latigo end through the loop you created when you crossed over.

Cross the loose end of the latigo over the top of your latigo layers and insert it through the saddle dee from the horse side out to secure the knot.

If this is the case, simply repeat steps 2 and 3.

You may need to take an extra wrap or two, depending on the length of your latigo.

After you have done your knot, tighten the straps. You want your latigo to be snug but not too tight. Pull the latigo entirely through the dee ring and to the left.

From the outside in, run the latigo through the saddle dee ring.

Make that the latigo is not twisted and is lying flat. Pull the latigo all the way through, but not too tightly.

From the horse’s belly side out, thread the latigo through the cinch ring.

The cinch should be placed around the horse’s heart girth, which is the narrowest area of the rib cage. Make sure the cinch is not twisted and is lying flat against the horse’s belly.

With your left hand, go beneath the horse’s belly and grab the cinch.

#Cinch knot how to#

To learn how to saddle your horse properly, go to How To Saddle A Horse. Because buckle tongues can break and latigos with insufficient holes to properly tighten the cinch can occur, every western rider should know how to tie a cinch knot. The near-side (left) ring of the cinch will have a buckle tongue, and the latigo will have a sequence of vertical holes for the buckle tongue to latch on to. Most cinches and latigos these days come with buckles. Tying a cinch knot or buckling the cinch are the two methods for attaching the latigo to the cinch. To secure the saddle to the horse, western saddles use a cinch and a latigo (or cinch strap).

#Cinch knot pro#

We will have you tacking up like a pro in no time with these simple, step-by-step instructions. It can be difficult to figure out how to tie a western cinch if you are new to western tack.